Brother HL-3450CN Series User Manual page 176

CHAPTER 6 OPTIONS
Unscrew the two screws that
2.
secure the rear plate of the main
controller board, and then pull out
the main controller board.
Unpack the DIMM and hold it by its edges.
3.
!
Caution
Do not touch the memory chips and the surface of the main controller board.
If static electricity collects, it may damage these electrical parts.
Hold the DIMM with your fingers
4.
on the side edges and thumb
against the back edge. Align the
notches on the DIMM with the
DIMM slot. (Check that the locks
on each side of the DIMM slot are
open, or outward).
6-20
Fig. 6-26
Fig. 6-27