Rockwood 31837 Instructions Manual
  1. Manuals
  2. Brands
  3. Rockwood Manuals
  4. Grinder
  5. 31837
  6. Instructions manual

Rockwood 31837 Instructions Manual

1/8" micro pencil die grinder
Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Item #31837
1/8" MICRO
PENCIL DIE GRINDER
INSTRUCTIONS

Advertisement

Table of Contents
loading

Related Manuals for Rockwood 31837

Summary of Contents for Rockwood 31837

  • Page 1 Item #31837 1/8" MICRO PENCIL DIE GRINDER INSTRUCTIONS...

  • Page 2: Specifications

    The ROCKWOOD 1/8” MICRO PENCIL DIE GRINDER is a high-quality precision tool perfect for many ® close-quarter projects. It features a positive 1/8” non-slip collet for quick, convenient and secure ac- cessory changes. A high rpm motor provides smooth operation, and the slim design fits virtually any- where a pencil would.

  • Page 3: Safety Information

    Always wear ANSI approved eye protection when operating this tool. HEARING DAMAGE HAZARD! • This Rockwood Pneumatic Tool emits high sound levels while operating. Use ANSI approved ear protection when operating. BURSTING HAZARD! • Do not exceed 90 psi (6.3 bar) of tool inlet pressure. Permanent tool damage and/or explosion could occur and cause personal injury.
  • Page 4 INJURY HAZARD! • This tool uses high-speed, highly abrasive cutting surfaces which can quickly cause injury. Keep fingers and hands away from moving parts when operating. Wear thick, well-fitting work gloves and keep loose clothing, sleeves, cords, jewelry and hair away from moving parts. •...
  • Page 5 SET-UP • Using a good quality Teflon sealing tape (Not Included), thread the 1/4” MNPT threads of the Inline Oiler into the NPT threads of the Male Quick Disconnect Inlet Fitting and tighten securely (FIG 1). • Once again, apply Teflon sealing tape (not included) onto the male 1/4” NPT threads of the Air Hose fitting then thread it into the Inline Oiler and tighten securely (FIG 1).

  • Page 6: Operation

    TO INSTALL OR SWITCH ACCESSORIES: • With air supply disconnected, Align the wrench slots of the Micro Grinder Body with the wrench flats of the Shaft. • Slide one of the 9mm Collet Wrenches into the Slots and over the wrench flats of the shaft (FIG 1).

  • Page 7: Troubleshooting

    TROUBLESHOOTING Insufficient volume of air Verify sufficient air supply to tool. (CFM) to oper- (4 CFM @ 90 PSI minimum requirement). Tool doesn’t ate tool respond to Throttle Moisture or rotation other contami- Check for moisture in air line and tool air inlet. nation in air supply Insufficient...

  • Page 8: Additional Items

    ADDITIONAL ITEMS #13003 Buff Bob Mini Cylinder Assortment #13051 Buff Bob Assortment Mini Cones If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.343.9353 >> email: techelp@eastwood.com PDF version of this manual is available online >> eastwood.com/31837manual The Eastwood Company 263 Shoemaker Road, Pottstown, PA 19464, USA US and Canada: 800.343.9353 Outside US: 610.718.8335 Fax: 610.323.6268 eastwood.com...

Table of Contents