The ROCKWOOD AIR HAMMER & CHISEL SET features a high-performance 4500 bpm (blows per minute) design for quick and efficient operation. It accepts any standard 0.401" Parker Taper shank air hammer tool bit and includes four of the most popular tool bit configurations.
Always wear ANSI approved eye protection when operating this tool. HEARING DAMAGE HAZARD! • This Rockwood Pneumatic Tool emits high sound levels while operating. Use ANSI approved ear protection when operating. BURSTING HAZARD! • Do not exceed 90 psi (6.2 bar) of tool inlet pressure. Permanent tool damage and/or explosion could occur and cause personal injury.
INJURY HAZARD! • This tool has high-speed, highly aggressive chiseling surfaces which can quickly cause severe injury. Keep fingers and hands away from moving parts when operating. Wear thick, well-fitting work gloves and keep loose clothing, sleeves, cords, jewelry and hair away from moving parts. •...
OPERATION INJURY HAZARD! Disconnect air supply from the Hammer to prevent accidental starting and potential injury while placing a tool bit in the bore. • Place the desired tool bit against FIG. 1 work piece and depress trigger to actuate hammering. Always use two hands to control tool.
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Insufficient volume Verify sufficient air supply to tool. of air (CFM) to Tool Doesn’t (4 CFM @ 90 PSI minimum requirement) operate tool Respond to Trigger Moisture or other Depression contamination Check for moisture in air line and tool air inlet in air supply Insufficient volume Verify sufficient air supply to tool...
Page 7
To order parts and supplies: 800.343.9353 >> eastwood.com...
ADDITIONAL ITEMS #70491 Eastwood Industrial Air Hose, 3/8" x 25' #70492 Eastwood Industrial Air Hose, 3/8" x 50' #13223 Face Shield with Ratcheting Headband #31476 Air Hammer Drift Pin Set If you have any questions about the use of this product, please contact The Eastwood Technical Assistance Service Department: 800.343.9353 >>...