Craig CHT884 Owner's Manual

Tower speaker system with color changing lights and bluetooth wireless technology

Advertisement

Size: 148.5(W) x 210(H)mm (A5)

Advertisement

Table of Contents
loading

Summary of Contents for Craig CHT884

  • Page 1 Size: 148.5(W) x 210(H)mm (A5)
  • Page 2: Limited Warranty

    LIMITED WARRANTY This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
  • Page 3 LIMITED WARRANTY...
  • Page 4: Power Source

    POWER SOURCE Insert the small plug from the supplied AC/DC Adaptor to the DC IN Jack on the rear of unit. Connect the AC/DC adaptor to a wall outlet having AC 100-240 V~, 50/60 Hz NOTE: This AC/DC Adpator is intended to be correctly orientated LOCATIONS OF CONTROLS 1.
  • Page 5: Location Of Control

    LOCATION OF CONTROL ANT (FM Antenna) POWER ON/OFF Switch DC IN Jack LINE IN Jack AUX IN Jack (Standby On/O k) Button INDICATOR 8. LED Button 9. SOURCE Button 10. VOL - (Volume Down) Button 11. VOL + (Volume Up) Button T U N E - / B u t t o n T U N E + /...
  • Page 6 LOCATION OF CONTROL (REMOTE CONTROL) (Play / Pause) Button (Standby On/O ) Button 8. TUNE + / Button 2. LED ON/OFF Button 9. VOL (Volume) +/- Buttons (Mute) Button 10. TREBLE +/- Buttons 4. SOURCE Button 11. BASS +/- Buttons 5.
  • Page 7: Assembling Method

    ASSEMBLING METHOD ASSMBLING METHOD Supplied screwdriver Assembly the two wooden bases to the bottom of unit by the supplied assembly screws and screwdriver as the illustrated above.
  • Page 8: Battery Precautions

    B UTTON CELL INSTALL/ REPLACE (REM OTE CONTROL) ~ Replacing the button cell for the remote control if it is drained: 1. Push then slide out the battery tray as the illustrated below. 2. Replace the button cell by a new CR2025 button cell with the polarity "+" face up as the illustrated below and the makings on the rear of remote control.
  • Page 9: Operation

    Buttons on the unit or Remote Control to Skip tracks. Notes: When the external BT Device searched the unit, our model number “CHT884” will appear on the display of external BT Device. If while pairing you are asked for a code please try "0000" or "1234".
  • Page 10 RADIO: 1. Power on the unit and enter to Radio mode as the instructed earlier. The color of the indicator on the top of unit will turns to Teal. station forward. Repeat the same procedures until the desired radio station was found and play station backward.
  • Page 11 3. Power on the unit and enter to LINE IN mode as the instructed earlier. The color of the indicator on the top of unit will turns to Purple. 4. Plays the music on the connected external Audio Player as usual. (Make sure the volume level of the external Audio Player is in high level.
  • Page 12: General Specifications

    3. Power on the unit and enter to AUX IN mode as the instructed earlier. The color of the indicator on the top of unit will turns to Green. 4. Plays the music/video on the connected external Audio/Video Player as usual. (Make sure the volume level of the external Audio/Video Player is in high level.

This manual is also suitable for:

Cht894

Table of Contents