Table of Contents
Advertisement
5
Setting, Unsetting, and Restoring the System
5.1
Setting the System: FULLSET
Siemens Building Technologies
Fire Safety & Security Products
The following functions are available to users by
entering using just their user code; these functions
do not require menu navigation on the Keypad.
User codes can be 4, 5, or 6 digits, depending
upon the Grade the system has been programmed
to.
A user's ability to see menus and options available
on the intrusion pontrol panel is programmed by
the installation engineer. If users cannot see an
option described in this manual, they do not have
rights to access that functionality.
When the user code is entered, the digits are
displayed as asterixes on the display and the left
function key displays the QUIT option. This is for
security reasons, so codes are not visible when
entered.
After entering the user code, the following options
are presented: FULLSET, PARTSET A, PARTSET B, MENUS. Scroll through
these options by using the up/down arrow keys.
The FULLSET option provides the following functionality:
Full protection to a building (opening of alarm
zones activates alarm)
Opening of entry/exit zones starts the entry
timer. If the alarm is not unset before the entry
timer expires, the alarm is activated
To select the FULLSET option, enter a valid user
code, and press SELECT (right soft key). The
second line of the display counts down the exit
timer and the buzzer sounds to indicate that the
user should exit the building. When the system
has been fully set, the LCD displays FULLSET on
the bottom line for approximately 10 seconds.
If the alarm fails to set, see Section 5.4
Setting, Unsetting, and Restoring the System
...FULLSET?...
EXIT
... PARTSET A?...
EXIT
...PARTSET B?...
EXIT
...MENUS...
EXIT
...FULLSET?...
EXIT
18/06/2008
SETTING 45 SECONDS
18/06/2008
SYSTEM FULLSET
SELECT
SELECT
SELECT
SELECT
SELECT
12:30
12:30
11
09.2008
Advertisement
Table of Contents
