Patio Deck - Rear (If So Equipped); Manual Ramp Door; Automated Ramp Door; Set Up The Patio Deck (Automated Ramp Door) - Jayco SEISMIC 2021 Owner's Manual

Patio Deck - Rear (if so equipped)

Caution should be taken not to exceed the maximum patio weight capacity and to maintain
even weight distribution.
Maximum capacity is 10 people 1500 lbs. (680 Kg) and an evenly distrib-
uted load when in the patio position. Failure to observe the weight limit or
use other than intended may result in property damage or serious personal
injury.
Stabilizers or leveling jacks MUST be used when the patio is deployed and
in use.
Unlatch and swing the Tailgater Kitchen (if equipped) (attached to the rear of the RV) out of
the way to lower the rear ramp door. (Refer to the Tailgater Kitchen section)

Manual Ramp Door

Patio support cables are attached to the ramp door and door jamb. The door is made to close
with the support cables attached. The support cables must be detached from the door so it
can be lowered and used as a ramp. Re-attach the support cables before closing the ramp
door.

Automated Ramp Door

The patio support cables, quick links and safety pins are stored in a toolbox recessed in the
floor of the garage area. Patio support cables MUST be detached from the ramp door and the
door frame before the ramp door can be closed. This would include the quick links on the
door frame, the safety pins on the ramp door, and the cables themselves.

Set up the Patio Deck (Automated Ramp Door)

Locate and secure the cables to both sides of the door frame and cargo door, by fastening one
end of the cable to the top of the door frame using a quick link fastener. Tighten the nut on
the quick link fastener once the cable is in place. Lifting up the door slightly, secure the other
end of the cable to the cargo door by inserting the safety pin through the bracket and cable.
Secure the safety clip on the end of the pin. Repeat the process on the other side of the door.
Section 4: Vehicle Operation
67