Brother CS-80 Operation Manual page 19

S2_brotherE.book Page 13 Thursday, February 13, 2003 11:03 AM
5 Slide the bobbin winder shaft to the right.
6 Place the spool of thread for the bobbin onto
the bobbin thread spool pin.
7 Slide the spool cap onto the bobbin thread
spool pin.
With the rounded side of the spool cap
positioned toward the left, slide the spool cap
onto the bobbin thread spool pin as far as
possible until the right side of the spool
touches the right end of the bobbin thread
spool pin.
CAUTION
G
Two spool cap sizes are available,
allowing you to choose a spool cap that
best fits the size of spool being used. If
the spool cap is too small for the spool
being used, the thread may catch on the
slit in the spool or the needle may break.
Note
G If a spool of thread 12 mm (1/2 inch) in
diameter and 75 mm (3 inch) high is
inserted onto the bobbin thread spool pin,
use the special spool cap.
2
1
1 12 mm (1/2 inch)
2 75 mm (3 inch)
Winding/Installing the Bobbin
1
13