Orient Print Messenger Operation Manual

A. Package contents
The parts that are mentioned hereafter are included in the
carton. Please contact our resellers if any parts are missing
or damaged.
B. About the Print Messenger
Exterior and structure（see figures below）
1—Light 2—Light pole 3—Top cover
4—MODE key 5—OK key 6—Bottom cover
7—Turn-plate 8—Bracket
C. Assembling the Print Messenger
1
 Mounting of the bracket
Mount the metal bracket with two nylon feet and two screws
onto the bottom of the printer as shown in the following
diagram. Then mount the two remaining nylon feet onto the
bottom of the printer opposite the metal bracket (see
drawing)
BTP-2002NP BTP-M270 etc.
 Mounting the Main Unit
Step 1: Insert the Main Unit in the plastic turn-plate of the
Bracket as shown in Figure 1.
FIGURE 1 FIGURE 2
Step 2：Rotate the Main Unit clockwise as shown in figures
2 and 3 if the printer is to be used on a horizontal surface. If
the printer is mounted on a vertical surface by means of our
Wall Mount System then the Main Unit should be rotated
anti-clockwise.
2
FIGURE 3 FIGURE 4
Step 3：After you have ensured that the printer is switched
off, the Main Unit can be connected to the Cashdrawer
connector at the back of the printer as shown in figure 5.
FIGURE 5
D. Printer key-pad
The printer module has two keys: MODE key and OK key
The Print Messenger has two modes, called "Operation"
and "Setting". The operation mode is used for operating the
Print Messenger; the settings mode is used for setting the
3
.