Pioneer BDP-09FD Service Manual page 60

1
• The first input numeric is displayed at the rightmost position then will be shifted to the left with subsequent key inputs,
A
as shown below:
No input
A "1" is input. (Even if a nonvalid numeric is input, the error message will not be displayed at this stage.)
A "2" is input. (Even if a nonvalid numeric is input, the error message will not be displayed at this stage.)
When the CLEAR key is pressed, the screen will return to the initial display.
A "3" is input. (Even if a nonvalid numeric is input, the error message will not be displayed at this stage.)
When the CLEAR key is pressed, the screen will return to the initial display.
B A "4" is input. (If the input 4-digit number is not a valid number, "> 1234" is instantly [0.2 sec] displayed.
Then an error message will be displayed.)
When the CLEAR key is pressed, the screen will return to the initial display.
The above "> 1234" is instantly (0.2 sec) displayed
then the Model Setting screen will be cleared.
• To correct the input data, press the CLEAR key on the remote control unit for service.
All the input numerics will be cleared.
C
• On the model indications
• The model number then the destination are indicated in the Model column.
• A full model number is indicated (16 one-byte characters at maximum).
• The model numbers and destinations are displayed in alphabetical and ascending numeric orders, from the top line
in the left column.
• If the corresponding number exists:
-> The model and region numbers are displayed for 2 sec. (Fig. 4)
-> Then the unit will be turned off.
[ C h e c k M o d e f o r
I n p u t t h e n u m b e r
D
> 0 1 3 4
O K !
M o d e l : B D P – 0 9 F D / K U / C A
E
• FL display
While the Model Setting screen is displayed:
If the input model number exists:
If the input model number does not exist:
F
60
1
2
M o d e l S e t t i n g ]
u s i n g t h e r e m o t e f o r S e r v i c e .
R E G I O N :
Fig. 4
(After this indication is displayed for 2 sec, the unit is turned off.)
2
3
1 A
BDP-09FD
3
4
4