Advertisement
4.
OPERATION
4.0
Before starting, consideration should be given to the positioning of the vehicle in relation to the external venting required
for the ducting.
4.1
The unit is normally stored in the vertical position with the 3 metre length of flexible ducting inside the aluminum tube.
4.2
Wheel the unit close to the vehicle.
4.3
To prepare the unit for use loosen the tube clamp butterfly nut and the two height adjusting knobs and swing the unit into
the horizontal position. Keep hold of the filter on the back end of the tube to stop it falling out. Slide the aluminium tube
within its clamping bracket until it is in balance and then tighten the plastic butterfly nut.
4.4
To adjust the height of the tube in relation to the exhaust, hold the aluminium tube either side of the clamps and slide it out
of the slot it is in and up or down to the required height. Move the clamps into the nearest convenient slots and tighten them.
4.5
Extend the flexible ducting and place the filter in a position where the exhaust fumes can be vented outdoors.
4.6
The unit should be positioned so that the exhaust pipe is within the cone but not touching it.
4.7
Connect the workshop air supply to the ball valve at the base of the cone using the hook up recommended in section 3.
Alternatively an adequately specifed portable air compressor can be used. See specification section 2.
4.8
Turn the air supply on and open the ball valve on the unit.
4.9
Start the vehicles engine and check that the exhaust fumes are being properly extracted. If adjustments are required to the
postioning of the unit, turn the engine off first.
NOTE: For cars with twin exhausts an accessory is available for separate
purchase. Order Model No: EFS07DE. See fig.2.
5.
MAINTENANCE
5.1.
Keep the extractor clean and repair/replace any damaged parts.
5.2
Clean the ducting outlet filter once a week. Refer to fig.3. Squeeze and
remove the spring clip 6. Remove the outer filter plate 5 and the two
layers of filter material 3 & 4. Wash the filter material in ordinary detergent
and let it dry. Place the inner grille 2 back into the filter housing 1 followed
by the two filters 3 & 4. Place the outer filter plate 5 over the filters and
retain all parts by squeezing and re-inserting the spring clip 6.
NOTE:
It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
fig.2
01284 757500
01284 703534
fig.1
fig.3
www.sealey.co.uk
Web
sales@sealey.co.uk
email
EFS07 - 1 - 190607
Advertisement
