Boston Acoustics Bravo Specifications

Boston Acoustics Bravo Specifications

Boston acoustics bravo: specifications
Hide thumbs Also See for Bravo:

Advertisement

High Performance Multi-Purpose Speaker

Advertisement

Table of Contents
loading

Summary of Contents for Boston Acoustics Bravo

  • Page 1 High Performance Multi-Purpose Speaker...
  • Page 2: Specifications

    The Boston Bravo is essentially one-quarter of a cylinder, allowing it to be mounted vertically at any height in a corner, or horizontally at the top of a wall, where wall and ceiling meet. Attaching the Boston Bravo to any surface is as simple as mounting the bracket to the wall, removing the grille from the speaker, and then attaching the speaker to the bracket using the supplied screws.
  • Page 3: How To Connect Your Speakers

    MONO, reverse the connections at one speaker only. You’ll hear a dramatic change in sound. The connection that yields the fuller bass and louder sound is correct. Connecting the Boston Bravo to Your Amplifier or Receiver 1. Connect the speaker terminals to the amplifier speaker outputs.
  • Page 4 Using the Boston Bravo on a Flat Surface The Boston Bravo can be used on a flat surface, such as a table, shelf or the floor. For horizontal placement that tilts up at 45º, both corner fillers must be used and the bracket must be removed. For untilted horizontal placement, the rear stand must be used with the mounting bracket attached (see “Mount the Speaker to the Bracket”...
  • Page 5 Connect the wire to the speaker’s terminals, taking care to maintain speaker polarity. (See “How to Connect Your Speakers” and “Basic Hookup” on page 3). Both the Boston Bravo and its bracket are symmetrical, so the speaker can be mounted with either its woofer or tweeter on top. In general, bass performance will be enhanced with the woofer as close to as many room surfaces as possible.
  • Page 6: Ceiling Clearance

    Rotating the Logo for Horizontal Mounting or Placement The logo plate on the Boston Bravo’s grille can be rotated 90° in either direction to enhance the speaker’s appearance when mounting or placing it in a horizontal position.
  • Page 7 However, if attaching speakers to the wall is not an option, then the Boston Bravos can be placed horizontally directly on the floor. Since the low frequency limit of the Boston Bravo is approximately 80Hz, speaker bass management should be set to "small."...
  • Page 8: Listening Levels And Power Handling

    Limited Warranty For five years from the date of purchase, Boston Acoustics will repair for the original owner any defect in materials or workmanship that occurs in normal use of the speakers, without charge for parts and labor.

This manual is also suitable for:

Bravo iiVr-m50Vr-mcVr940

Table of Contents