Table of Contents
Advertisement
Ceiling Clearance
If the Boston Bravo is to be mount-
ed so that the top or the side of the
speaker will meet a flush surface,
either a wall (horizontally) or the
ceiling (vertically), then measure the
exact distance as shown here from
that surface to the top or side of the
bracket.
Mount the Speaker to the Bracket
Remove the speaker's grille by grasping the back of the cabinet in one hand, while gently pulling the grille away
with the other hand.
Align the openings in the back of the speaker with the two
posts protruding from the bracket as shown below.
Gently remove any slack in the speaker wire as you push
the speaker firmly onto the bracket.
Attach the speaker to the bracket by inserting the
supplied screws through the holes in the front of the
speaker and into the bracket as shown below (do not over-
tighten the screws).
Replace the grille on the speaker.
NOTE: The Boston Bravo is not securely attached to its
bracket unless the screws are used.
Rotating the Logo for Horizontal Mounting or Placement
The logo plate on the Boston Bravo's grille can be rotated 90° in either direction to enhance the speaker's
appearance when mounting or placing it in a horizontal position.
6
ceiling
or wall
5
/
inches (16mm)
8
To rotate the logo:
Remove the grille and turn it over.
Locate the logo's split post protruding through the
bottom inside portion of the grille.
Place your thumb against the split post and press
firmly until the logo pops out of the grille.
Rotate the logo to the desired position and re-
insert the split post back into the hole until it snaps
into place.
ceiling
3
/
3
inches (86mm)
8
Advertisement
Table of Contents
