Mitsubishi Pajero 2001 Manual page 8

00-8
GENERAL -
MB991529
Indication of diagnosis code by warning lamp
When the diagnosis code No.24 is output
1.5 secs.
On
Off
Pause Tens
time 3 signal
secs.
NOTE
*: Even if the ABS system is normal, removing the valve relay causes the diagnosis code No.52 to
be output.
METHOD OF ERASING DIAGNOSIS CODES
WHEN USING THE MUT-II
Connect the MUT-II to the diagnosis connector and erase the diagnosis code.
Caution
Turn the ignition switch to "LOCK (OFF)" position before connecting or disconnecting the MUT-II.
WHEN NOT USING THE MUT-II
1. Turn the ignition switch to "LOCK(OFF)" position.
2. After disconnecting the battery cable from the battery ( - ) terminal for 10 seconds or more, reconnect
the cable.
3. After the engine has warmed up, run it at idle for about 15 minutes.
How to Use Troubleshooting/Inspection Service Points
WHEN USING THE WARNING LAMP
1. Use the special tool to earth No.1 terminal (diagnosis
2. Turn on the ignition switch.
3. Read out a diagnosis code by observing how the warning
Applicable systems
System name
A/T
ABS
SS4 II
Hydraulic Brake Booster(HBB)
0.5 sec.
0.5 sec.
Place Units
division signal
2 secs.
control terminal) of the diagnosis connector.
lamp flashes.
When no diagnosis code is output*
On
Off
Warning lamp name
Neutral position indicator lamp
ABS warning lamp
4WD warning lamp
Brake warning lamp
0.5 sec. <SS4 II, A/T>
0.25 sec. <ABS, HBB>