Advertisement
Electrical Wiring
All
3 3 ~ 9
POWER DRIVE amplifiers are equipped with easy access screw terminals.
These terminals are nickel-plated in order to ensure excellent electrical contact and
to resist corrosion.
When making electrical connections to the amplifier, please observe the following:
.
Use at least 4 gauge or heavier wires for power and ground connections.
Connect the BATTERY-(+) terminal to the positive
(+)
terminal of the car battery.
Be sure to install a fuse (or other circuit protection device) within 18 inches of the battery.
Wire the amplifier directly to the car battery.
For the ground connection, use the shortest possible wire to a good chassis ground point.
Wire the Remote connection to the remote turn-on lead of vour eaualizer or source unit.
antenna lead).
- - I
Power fuses protect both the amplifier and the electrical system of your vehicle from fault
conditions. If you must replace the fuse in your POWER DRIVE amplifier, use a fuse of exactly
ing of fuse may result in damage or fire.
-.
Mounting the Amplifier
Mark the location for the mounting screw holes by positioning the amplifier where you wish
to install
it
an
e$fAwffiounting screws) inserted in each mounting hole
to mark the mo
ounting surface is carpeted, measure the hole centers and
v
k with a felt tip pen.
Drill pilot holes in the mounting surface for the mounting screws and insert the mounting
screws into these holes.jTighten them securely.
Note: Be sure to take note ok.any wires, lines or other devices in your vehicle which may be
located behind any mounting surface!
Advertisement
