Frigidaire Gallery GRSC2352AD Use & Care Manual page 11

To remove the freezer door:
1. Remove the 3 screws from the cover
over the top door hinge.
2. Lift hinge cover straight up and off.
3. Release the wires from the routing clip.
IMPORTANT
To prevent wire damage, ensure the
wires are rerouted through the routing
clip when reassembling the hinge cover.
Disconnect the multi-wire cable
connector located above the top
hinge. Press the cable and lock and
separate the 2 cables.
4. Trace lightly around the hinge with a
pencil. This makes reinstallation easier.
5. Detach the water tube from the
connector located below the freezer
door. The connector releases when
you press its outer sleeve inward.
6. Remove the 2 screws from the top
hinge. Remove the hinge pulling the
multi-wire cable through it. Lift the
door off the bottom hinge.
7. Remove the 2 bottom hinge screws
and hinge if necessary.
DOOR REMOVAL
To Disconnect
1. Press outer ring against face of
fitting
2. Pull to
remove tube
To Connect
Insert tube and push until mark
touches face of fitting
Closer
Pin
Hinge
Adjustable Hinge (some models)
Hinge
Assembly Screws
Non-Adjusting Hinge (some models)
8. Lay the door on its side to avoid
damage to the water tube extending
from the bottom hinge.
To reinstall the freezer door, reverse the
above steps.
CAUTION
Be sure doors are set aside in a secure
position where they cannot fall and
cause personal injury.
11
Door
Water
Line
Tubing
Hinge
Screws
Assembly
Door
Water
Line
Tubing