Bose 321 Series III Owner's Manual page 14

System Setup
Figure 11
Right-angle connector that
attaches to the Acousti-
mass module
Figure 12
Basic connections to the
media center
14
4. On the Acoustimass ® module, insert the right-angle connector (Figure 11) of the Acousti-
mass module cable into the jack labeled MEDIA CENTER. On the rear panel of the media
center, insert the other end of the cable into the jack labeled ACOUSTIMASS MODULE.
Firmly tighten the two screws at each end of the cable.
5. On the rear panel of the media center, insert one end of the supplied video cable (marked
in yellow) to VIDEO OUTPUT (Figure 12). Insert the other end of the cable into the video
input on your TV.
CAUTION: Do not plug the Acoustimass module into an AC power (mains) outlet until all the
components are connected.
VIDEO OUTPUT
75 AM
FM LOOP
ANTENNA ANTENNA
To TV
video input
Note: Before using your TV to play a DVD or other video source, be sure to read the Impor-
tant Note on page 16.
S-video as an alternate means to connect to the TV
An S-video input jack, provided on many TVs, delivers a higher-quality TV picture than the
composite video output connection shown above.
To make this alternate connection, insert the end of an S-video cable from the TV into the S-
VIDEO OUTPUT on the media center. This cable may be purchased from your Bose
a local electronics retailer.
AM256950_02_V.pdf • January 29, 2002
Speaker
cable
AUDIO INPUT VIDEO VIDEO AUDIO SPEAKERS
VIDEO IDEO 2 AUX INPUT OUTPUT OUTPUT
D
D L L L C C L
ACOUSTIMASS MODULE
OPTICAL R R D R
S S R
AC INPUT
MUSIC CENTER
AC input
jack
Acoustimass
module cable
® dealer or