Brother MFC-8680DN Network User's Manual page 64

l
If the LCD shows Connected, the machine has successfully connected to your access point/router. You
can now use your machine in a wireless network.
If the LCD shows Connection Error, a session overlap has been detected. The machine has
detected more than one access point/router on your network with the SecureEasySetup™ mode, the
Wi-Fi Protected Setup mode or AOSS™ mode enabled. Make sure that only one access point/router has
the SecureEasySetup™ mode, the Wi-Fi Protected Setup mode or the AOSS™ mode enabled and try
starting from step i again.
If the LCD shows No Access Point, the machine has not detected your access point/router on your
network with the SecureEasySetup™ mode, the Wi-Fi Protected Setup mode or AOSS™ mode
enabled. Move the machine closer to your access point/router and try starting from step i again.
If the LCD shows Connection Fail, the machine has not successfully connected to your access
point/router. Try starting from step i again. If the same message is indicated again, reset the machine
back to the default factory settings and try again. (For resetting, see Restoring the network settings to
factory default on page 123.)
LCD messages when using the SES/WPS/AOSS™ control panel menu
LCD shows
Setting WLAN
Connecting SES
Connecting WPS
Connecting AOSS
Connected
Connection Error
No Access Point
Connection Fail
Wireless configuration for Windows
Connection status
Searching or accessing the access
point, and downloading settings from the
access point
Connecting the access point
Connection succeeded.
Session overlap has been detected.
The access point detection failed.
Connection failed.
®
using the Brother installer application (For MFC-8890DW)
Action
Check that only one router or access point has
the SecureEasySetup™ mode, the Wi-Fi
Protected Setup mode or AOSS™ mode enabled
and try starting from step i again.
Move the machine closer to your access
point/router and try starting from step i again.
1 Try starting from step i again.
2 If the same message continues, reset the
machine back to the factory settings and try
again.
—
—
—
54
4
4