Philips Sonicare DiamondClean 9000 Manual page 29

2 Remove and discard the brush head. Cover the entire handle
with a towel or cloth.
1
2
3 Hold the top of the handle with one hand and strike the
handle housing 0.5 inch above the bottom end. Strike firmly
with a hammer on all 4 sides to eject the end cap.
Note: You may have to hit on the end several times to break
the internal snap connections.
4 Remove the end cap from the toothbrush handle. If the end
cap does not release easily from the housing, repeat step 3
until the end cap is released.
5 Holding the handle upside down, press the shaft down on a
hard surface. If the internal components do not easily release
from the housing, repeat step 3 until the internal components
are released.
29
English