Eclipse EGO9 Operator's Manual page 38

74.
SYMpTOM pOSSIBLE CAUSE
Although a fresh battery has been fitted, the the battery has been fitted incorrectly.
Ego9 will not switch on.
the battery terminals are not making
proper contact with the battery.
the battery does not seem to last very long. the battery type is of a low quality.
the Ego9 leaks from the solenoid. the gasket is damaged and/or not seated
correctly in its designated pocket in the
solenoid body.
damaged Ego9 solenoid.
lpr is supercharging causing intermittent
leaking.
solenoid spool shaft is damaged or dirty.
damaged or incorrect seals on rammer.
it is leaking from the barbs.
it is over-pressurizing from damaged seals
on the valve chamber.
the Ego9 leaks down the barrel. leaky Exhaust valve.
damaged valve seat.
gas vents quickly down barrel as soon as it incorrect seal on front of valve guide.
is gassed up.
the Exhaust valve has become jammed in
the valve guide.
QUICK GUIDE
SOLUTION
CONTENTS
ORIENTATION
fit the battery correctly with the positive QUICK SET-UP
terminal nearest to the side of the frame.
USING YOUR EGO9
MENU TREE
remove the battery, gently bend the
terminals towards where the battery will sit ADVANCED SET-UP
and then replace the battery.
MAINTENANCE
FAULT FINDING FAULT FINDING
use an alkaline or lithium battery. do not
SERVICE CENTERS
use a low quality or rechargeable battery.
PARTS LIST
SPARES & ACCESSORIES
replace the gasket if damaged using
Ego9 parts kit. Ensure the gasket is seated
correctly.
replace Ego9 solenoid.
clean lpr piston seal.
inspect regulator seal (in lpr piston) and
regulator seat (in lpr body). replace if
necessary.
clean or replace if required.
replace seals.
check hose for cuts or replace barbs.
change valve chamber seals.
replace Exhaust valve.
replace valve guide and o-rings.
replace front seals on valve guide with
013 nbr70.
replace Exhaust valve and valve guide as
necessary (see maintenance section).
75.