Tetra Crescent 3 Quick Setup Manual

Start Here - Crescent 3 & 5 Gallon Aquarium System
1
Parts Check
Lid
Base
Lid
Screws (2)
Base
3
Prepare Aquarium
NOTE:
DO NOT move aquarium
after it is filled with water.
Water Level
at Filter Lip
Spillway
C.
Water level should be
at the Filter Lip Spillway.
For questions and concerns contact Customer Support 800.526.0650 • www.tetra-fish.com
LED Light Assembly
Light Switch
LED Light
Clamp
Thumb
Pump
Motor
Power Supply
Power Cord
4
Install LED Light
A.
Hang LED Clamp on back of Aquarium with flat surface
facing into Aquarium. Insert thumbscrews into clamp to
secure. DO NOT over tighten.
B.
Room into the Clamp.
Temperature
C.
Insert Power Supply
A.
Cord into jack on bottom
Fill Aquarium
of LED light. Jack is visible
with gravel and
from underside and should
décor.
be outside of Aquarium.
B.
Add water and
Tetra AquaSafe Plus.
®
2
Filter Setup
Micro Filter Assembly
A.
Using the adjustable Filter
Hanger and Suction Cup
attach Micro Filter Assembly
Filter
Cartridge
inside Aquarium, 1/2 inch
below the Aquarium Lid.
B.
Filter Lip Remove Filter Cartridge
(Adjustable)
Filter
Spillway
from package and rinse.
Hanger
C.
Insert Filter Cartridge
into Housing.
Suction
NOTE:
Cup
Filter
Housing
every 2 to 3 weeks for optimal
fish health.
Impeller
D.
Make sure Pump is firmly
Impeller
Cover attached to Housing.
Impeller Well
B
Insert LED Light
C
Power
Supply Cord
Filter Power Cord
Quick Setup Guide
Back View
Cord Cord
Clip Clip
Replace Filter Cartridge
D
5
Start Your System
A.
Place Lid on Aquarium. Use cutouts in Lid for
Filter and LED Light Clamp.
LED Light into power outlet.
A
LED Light Switch
(I) ON - (O) OFF
Always:
Make a
Drip Loop (for safety).
© 2012 Tetra Holding (US), Inc.
Tetra®, AquaSafe® are registered trademarks
B
A
C
Front View
B.
Plug the Filter and
Never:
Run the filter
without water in it.
01/12 29002_901