Scan To Ftp (For Mfc-5890Cn And Mfc-6490Cw) - Brother DCP-6690CW Network User's Manual

Scan to FTP (For MFC-5890CN and MFC-6490CW)

The details required to use Scan to FTP can be entered manually at the control panel to pre-configure and
store the details in an FTP Profile. You can configure up to five FTP server profiles.
Passive Mode
You can set Passive Mode to OFF or ON depending on your FTP server and network firewall configuration.
By default this setting is ON. In most cases this setting can remain as default.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
Press a or b to choose Scan to FTP.
Press OK.
d
Press a or b to choose Passive Mode.
Press OK.
e
Press d or c to choose On or Off.
f
Press Stop/Exit.
Port number
You can change the port number used to access the FTP server. The default for this setting is port 21. In most
cases this setting can remain as default.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
Press a or b to choose Scan to FTP.
Press OK.
d
Press a or b to choose Port Number.
Press OK.
e
Enter the port number.
Press OK.
f
Press Stop/Exit.
Control panel setup
6
6
6
6
107