Related Manuals for Nokia RA-2
Summary of Contents for Nokia RA-2
- Page 1 Nokia Customer Care 5 - Disassembly/ Reassembly Instructions Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
- Page 2 RA-2/3 Nokia Customer Care 5 - Disassembly & Assembly Instructions [This page left intentionally blank] COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.
-
Page 3: Table Of Contents
Before you start....................5 Required tools for disassembly................5 Disassembling lower block................. 5 Disassembling upper block ................11 Changing flex cover ..................16 Reassembling keypad frame ................18 Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved. - Page 4 RA-2/3 Nokia Customer Care 5 - Disassembly & Assembly Instructions [This page left intentionally blank] COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.
-
Page 5: Ra-2/3 Disassembly/Reassembly Instructions
Disassembling lower block 1. Protect the window with a plastic foil to avoid dust and scratches. 2. Push down the BATTERY COVER LATCH before opening the BATTERY COVER. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved. - Page 6 5. Unlock the hooks along the edge of the KEYPAD FRAME as shown. 6. Bend the left side of the KEYPAD FRAME carefully and unlock the snaps as shown. COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.
- Page 7 8. Repeat the same procedure when opening the next snap. 9. Remove the KEYPAD FRAME. Do NOT re-use the KEYPAD FRAME! 10. Remove the PDA KEYMAT. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
- Page 8 18Ncm. 12. Remove the QWERTY ASSY. 13. Use SRT-6 to open the connector. Note! Be careful when opening the con- nector. 14.Lift out the UPPER BLOCK. COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.
- Page 9 16.Lift the ENGINE MODULE a bit and remove it from the B-COVER. 17.Use SRT-6 to push out the CAMERA MODULE from its holder 18. Lift out the CAMERA MODULE. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
- Page 10 20. Use the DC-PLUG to remove the DC-JACK. 21.Remove the MICROPHONE with tweezers. 22.The BATTERY DECK ASSY is attached to the B-COVER with six snaps. Use SRT-6 to push out the BATTERY DECK ASSY. COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.
-
Page 11: Disassembling Upper Block
2. Use SRT-6 to push in the A-COVER LOCKING and unlock the A-COVER. 3. Remove the A-COVER ASSY. Fit a protective foil inside the A-COVER window. 4. Remove the CMT KEYMAT. Note the guide pins when reassembling. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved. - Page 12 Always use a new SHIELD when reassembling. 6. Remove the SHIELD. 7. Take care of the EARPIECE. Protect the CMT LCD MODULE with a foil. COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.
- Page 13 8. Use tweezers to remove the EARPIECE. 9. Use SS-34 to open the LCD connector. 10.Lift out the LCD MODULE. 11.Use SRT-6 as a lever to open the A-COVER LOCKING. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
- Page 14 12.Lift out the A-COVER LOCKING. 13.Use SRT-6 to open the connector. 14.Use a slotted screwdriver as a lever to open the clip. 15. Repeat the same procedure on the right side. COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.
- Page 15 16. Lift out the UI CHASSIS as shown. 17.The PDA LCD MODULE is attached with an adhesive tape to the C-COVER. Push the LCD MODULE with two fingers slowly and the adhesive peels away. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
-
Page 16: Changing Flex Cover
2. Use SRT-6 to remove the remaining adhesive tape. 3. Use tweezers to take a new FLEX COVER. 4. Place the new FLEX COVER on the UI FLEXFOIL. COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved. - Page 17 RA-2/3 5 - Disassebmly & Assembly Instructions Nokia Customer Care 5. Carefully press the FLEX COVER onto the UI FLEXFOIL. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
-
Page 18: Reassembling Keypad Frame
2. Always start from the left side of the QWERTY FRAME when assembling the unit. 3. Carefully press the upper side of the QUERTY FRAME onto its place. 4. Ensure that both snaps on the front side are properly locked. COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved. - Page 19 RA-2/3 5 - Disassebmly & Assembly Instructions Nokia Customer Care 5. Press both COVERS together. Issue 1 09/04 COMPANY CONFIDENTIAL Copyright © 2004 Nokia. All Rights Reserved.
- Page 20 RA-2/3 Nokia Customer Care 5 - Disassembly & Assembly Instructions [This page intentionally blank] COMPANY CONFIDENTIAL Issue 1 09/04 Copyright © 2004 Nokia. All Rights Reserved.