Related Manuals for Nokia RH-23 Series
Summary of Contents for Nokia RH-23 Series
- Page 1 Customer Care Solutions RH-23 Series Transceivers Disassembly and Assembly Instructions Nokia Corporation Issue 1 02/2004 Company Confidential...
- Page 2 Table of Contents Page No RH-23 Product Selection ....................3 Accessories List ......................4 Technical Specifications ....................6 General Specifications of Transceiver RH-23 .............6 Battery endurance ......................7 Environmental conditions ..................7 Transceiver Features ....................8 Electrical Characteristics .....................9 Nokia Corporation. Page 2 Issue 1 02/2004...
-
Page 3: Upper Block Disassembly
Antenna Radiator will be destroyed during ® bly, the reverse order and a Torx Plus driver with a this removal procedure. torque of 28Ncm have to be used. Always use new gel screws for assembly! Nokia Corporation. Issue 1 02/2004 Page 3... - Page 4 Remove the IHF Housing. A screwdriver can be used to pull up the IHF-Speaker form its guidance. Use tweezers as a lever to open the Coax Connector. Open the connector with SRT-6 carefully. Nokia Corporation. Page 4 Issue 1 02/2004...
- Page 5 Also protect the color LCD with a film. The black & white LCD is attached with two snaps to the Upper Frame. Release the snaps by using the SRT-6 and the LCD drops out. Nokia Corporation. Issue 1 02/2004 Page 5...
- Page 6 Place SRT-10 as shown in the picture Camera Shield. and unlock the snaps on booth sides. Note releasing order. Use tweezers to take the Camera Module away. Camera Module comes up automatically when snaps are released. Nokia Corporation. Page 6 Issue 1 02/2004...
-
Page 7: Lower Block Disassembly
6 screws. For assem- remove the A-Cover Lower. ® bly, the reverse order and a Torx Plus driver with a torque of 28Ncm have to be used. Always use new gel screws for assembly! Nokia Corporation. Issue 1 02/2004 Page 7... - Page 8 Upper Block Take the Engine Module away. To avoid damage to the B-Cover Lower see also video clip on Care Point. Remove the Vibra Retainer by using a slotted screwdriver as a lever. Nokia Corporation. Page 8 Issue 1 02/2004...
- Page 9 The Vibra Motor can be removed easily. Take care of the Take away the Microphone by using the dental tool. right position when assembling. Tweezers can be used to remove the DC-Jack. Be careful not to damage spring contacts. Nokia Corporation. Issue 1 02/2004 Page 9...
- Page 10 Be carefully not damage the components on the PWB. Put the new Domesheet onto the Domesheet Assembly Remove the protection film. Tweezers can be used for Jig. Mind the guiding pins. retaining the Domesheet. Nokia Corporation. Page 10 Issue 1 02/2004...
- Page 11 Finally check that the holes of the Domesheet are Remove the protection film from UI PWB Module. centered to the UI PWB module holes. Ensure also, that there are no bubbles in Domesheet film. Nokia Corporation. Issue 1 02/2004 Page 11...
- Page 12 RH-23 Company confidential Disassembly and Assembly Instructions CCS Technical Documentation [This page intentionally left blank.] Nokia Corporation. Page 12 Issue 1 02/2004...