1.13 MAIN PCB ASS'Y, PRINT UNIT
(1) Disconnect the two connectors.
(2) Disconnect the connector, and separate the MAIN PCB ASS'Y and the PRINT UNIT.
NOTE (Assembly)
Using the edge of the head heatsink as a guide, fold the FLAT CABLE as shown in the figure.
Set the INK CASSETTE and check if it comes out smoothly.
If the fold on the FLAT CABLE is not enough, the INK CASSETTE will not come out.
(1) Connectors
NOTE (Assembly)
Head heatsink
16mm
Head heatsink
14mm
(2)
MAIN PCB
ASS'Y
(2)
Connector
10mm
23mm
(2)
PRINT UNIT
13