Table of Contents
Advertisement
Radio operation
Selecting a waveband
With this car radio you can select between
the following wavebands:
FM 87.5 - 107.9 MHz
AM 530- 1710 kHz
Select the desired waveband by
l
pressing the BNTS button.
Station tuning
Automatic seek tuning A/V
Press A or
the car radio will auto-
;
V
l
matically search for the next station.
If you hold A/v pressed up or down on the
rocker switch, seek tuning will speed up in
the upwards or downwards direction.
Automatic seek tuning
Down
V
Manual tuning with C-Z >>
You can also tune into a station manually.
Press << >>; the frequency will
l
change in short intervals in the down-
wards or upwards direction.
If you hold CC >> pressed to the left or the
right on the rocker switch, the frequency
scan will speed up.
Switching between the memory
banks (FM)
You can switch between the memory banks
tions and recall them later.
The currently selected memory bank ap-
pears in the display.
Press the BNTS button as many
l
times as necessary until the desired
memory bank lights up in the display.
Storing stations
On FM, you can store six stations on the
preset buttons 1, 2, 3, 4, 5, 6 for each of
the memory banks (FMl, FM2, FMT).
You can also store six stations on AM.
Select the waveband by pressing
l
BAITS.
Tune into a station with the rocker
l
switch (either automatically A/V or
manually << >>).
Press the desired preset button until
l
the radio resumes play after the mut-
ing (takes approximately 2 seconds)
or until you hear a beep.
Now the station has been stored.
The display will temporarily indicate which
preset button is currently activated.
Recalling stored stations
You can recall any stored station at the
touch of a button.
Select the waveband by pressing
l
BAITS. For FM, also choose the cor-
responding memory bank by pressing
the BMS button as many times as
necessary until the desired bank ap-
pears in the display.
Press the corresponding preset button
l
briefly to recall the station.
Scanning stations with
Preset Scan
You can scan all of the radio stations on
AM or FM.
The scanned stations of the current wave-
band will appear briefly one after the other
in the display.
Start
Scan:
Preset
Press PS briefly.
l
"PS-Scan" and the station name or frequen-
cy will appear alternately in the display.
Advertisement
Table of Contents
