Beckett TR3LT10 Instructions Manual page 2

GFCI C
A. To attach Lights to Transformer.
B. Do not repair or tamper with cord or plug.
C. The plug must be plugged into a GFCI grounded electrical outlet (120V only) that is in accordance with all codes and ordinances.
CAUTION:
Mount the transformer with cable terminals pointed down towards the ground at least 1 foot above ground
on a vertically flat surface and at least 10 feet away from water.
CAUTION!
Improper mounting
can result in failure
of the power unit.
TRANSFORMER CAPACITY:
Make sure that the total number of lamps connected to
the transformer does not exceed the transformer 40
wattage output capacity. The VA rating, noted on the
back of the transformer, determines the maximum
number of lights that can safely be connected to the
transformer. To determine this, divide the transformer
VA rating by the wattage rating of a submersible light.
TO TEST YOUR LIGHTS:
•
Make sure the Label covers
the Light Sensor.
•
Wait for the 30 Second Delay.
•
The Lights should shine, if not,
follow the directions on
replacing the halogen bulb.
B
12"
10'
Removable Label
Light Sensor
A
Light Cable
DIRECTIONS:
CAUTION!
THIS UNIT IS NOT REPAIRABLE.
The transformer contains no
serviceable parts. If the power unit
provides no output to the lights, replace
the transformer.
The Lights may be operated
dry or submerged.
Accent your fountain by placing
lights on the ground and adjust
the angle to your satisfaction!
- 2 -