CITROEN C3 Picasso 2011 Owner's Handbook Manual page 98

This ISOFIX mounting system provides
reliable, safe and fast fi tting of the child
seat in your vehicle.
ISOFIX child seats are fi tted with two
latches which are secured easily on
these rings A .
Some also have a top tether belt which
can be attached to ring B .
To attach this belt, raise the head re-
straint of the seat, then pass the buckle
between the rods. Then fi x the buckle
on ring B , then tension the top tether
belt.
If a child is not installed in a vehicle cor-
7
rectly, the child's protection in the event
of a collision will be compromised.
To know which ISOFIX child seats can
be installed in your vehicle, see the ta-
ble of seating positions for ISOFIX child
seats.
The rear seats must be in the fully back
position to install ISOFIX seats.
C H I L D S A F E T Y
APPROVED FOR YOUR VEHICLE
This child seat can also be used on seats which are not fi tted with ISOFIX
mountings. In this case, it must be attached to the vehicle seat using the
three point seat belt.
Follow the instructions for fi tting the child seat given in the seat manu-
facturer's installation guide.
RÖMER Duo Plus ISOFIX
(size category B1 )
Group 1: from 9 to 18 kg
Installed only in the forwards-facing position.
Fitted with an upper strap to be secured on the up-
per ring B , referred to as the TOP TETHER.
Three seat body angles: sitting, reclining, lying.
Adjust the front seat of the vehicle so that the
child's feet do not touch the back of the seat.