Call Forwading Set/Reset By Mat/Cat - NEC NEAX 2000 Programming Manual

CALL FORWARDING SET/RESET BY MAT/CAT
PROGRAMMING
To set or reset the Call Forwarding service from a MAT/CAT, use the following command.
START
CME6 Use CME6 Y=00-03 for Call Forwarding
and CME6 Y=04-05 for Split Call Forward-
ing. To reset the service, assign "CCC" to
the second data of each Y number.
END
DESCRIPTION
CALL FORWARDING SET/RESET BY MAT/CAT
Y=00 CF-All Calls
•
Y=01 CF-Busy Line
•
Y=02 CF-Don't Answer
•
Y=03 CF-Busy Line/Don't Answer
•
(1) X-XXXXXXXX: Station No.
(2) Destination No.
<Destination=Extension>
X-XXXXXXXX: Station No.
<Destination=Outside Party>
X-XX +
X-XX : Outgoing Trunk/LCR Group Ac-
,
: Separate Mark
YY....Y: Called No. (Max. 26 digits)
<Destination=Attendant Console>
E000: Attendant Console
Y=04 Split CF-ALL Calls
•
Y=05 Split CF-Busy Line/Don't Answer
•
(1) X-XXXXXXXX: Station No.
(2) 0: Target Station for Split CF (Block 0)/
ATT
1: Target Station for Split CF (Block 1)
2: Target Station for Split CF (Block 2)
3: Target Station for Split CF (Block 3)
4: Target Station for Split CF (Block 4)
5: Target Station for Split CF (Block 5)
6: Target Station for Split CF (Block 6)
7: Target Station for Split CF (Block 7)
8: Target Station for Call Forwarding
9: Station Speed Dialing (Block 0)
– 94 –
DATA
,
+ YY....Y
cess Code (1-2 digits)
A2088-10