Update Procedure; If Update Is Not Displayed - Samsung HW-T550 User Manual

– Connected rear R2xxx

Update Procedure

Important: The updating function erases all user
settings. We recommend you write down your
settings so that you can easily reset them after
the update. Note that updating the firmware
resets the subwoofer connection too.
1. Connect a USB thumb drive to the USB port
on your computer.
Important: Make sure there are no music
files on the USB thumb drive. This may cause
the firmware update to fail.
2. Go to the Samsung website at
https://www.samsung.com/us/support/
downloads/ on your computer
Model Number and enter the model of your
Soundbar. Select manuals and downloads
and download the latest software file.
3. Save the downloaded software to a USB
stick and select "Extract Here" to unzip the
folder.
4. Turn off the Soundbar and connect the USB
stick containing the software update to the
USB port.
5. Turn on the Soundbar and source change to
"USB" mode. Within 3 minutes, "UPDATE" is
displayed and updating begins. When the
update finishes, the Soundbar turns off.
6. Turn on the Soundbar and press the
-/+ (Volume) button on the top panel for
5 seconds. "INIT" appears on the display and
then the Soundbar turns off.
The update is complete.
• This product has a DUAL BOOT function.
If the firmware fails to update, you can
update the firmware again.
7. Restore your settings on the Soundbar.

If UPDATE is not displayed

1. Turn off the Soundbar, disconnect and then
2. Disconnect the Soundbar's power cord,
NOTES
• The firmware update may not work properly
• Do not disconnect the power or remove the
select Enter

• After the update is completed, the user setup
• Mac OS users should use MS-DOS (FAT) as the
• Updating via USB may not be available,
ENG - 29
reconnect the USB storage device that
contains the update files to the Soundbar's
USB port.
reconnect it, and then turn on the Soundbar.
if audio files supported by the Soundbar are
stored in the USB storage device.
USB device while updates are being applied.
The main unit will turn off automatically after
completing the firmware update.
in the Soundbar is initialized so you can reset
your settings. We recommend you write
down your settings so that you can easily
reset them after the update. Note that
updating firmware resets the subwoofer
connection too.
If the connection to the subwoofer is not
re-established automatically after the
update, refer to page 6.
If the software update fails, check if the USB
stick is defective.
USB format.
depending on the USB storage device
manufacturer.