ADTRAN TOTAL ACCESS OPTI-T200 Manual

OPTI-T200
Off
Green
Yellow
Flashing Yellow Unit is in Out-of-Service – Maintenance mode
Red
Green
1310 nm
1184400L1 Yellow
Flashing Yellow Unit in Test (e.g. Loopback)
TX
Red
Flashing Red
DS3
Off
RX
Green
Yellow
STATUS
Flashing Yellow Unit in Test (e.g. Loopback)
OPTICS
Red
Flashing Red
DS3
E
N
E
Connect to terminal using a serial cable with a male DB-9 connector.
T
Set VT100 terminal emulation to 9600 bps, 8 Data Bits, No Parity, 1 Stop Bit,
TX
and No Flow Control.
Baud rate is configurable at 9600, 19,200, 38,400 or 115,200 bps.
The OPTI-T200 is designed to work in a back-to-back mode of operation,
OPTI-T200 to OPTI-T200. It uses a standard 1310 nm OC3 signal to interface
between the systems and provides a single DS3 signal to the loop. The
OPTI-T200 provides DCC communication with TL1 support. A craft port and
RX an Ethernet port are available on the front panel for management. The
OPTI-T200 is a T200 mechanics card, which will fit standard T200 and T400
enclosures.
C
R
Compliant with SONET standards, the OPTI-T200 functions as a terminal
A
multiplexer, detecting standard optical, SONET, and DS3 related alarms and
F
T
conditions. The OPTI-T200 is easily managed with TL1 or TCP/IP commands,
or Telnet sessions separately to each system or via the craft interface.
C A U T I O N C A U T I O N !
SUBJECT TO ELECTROSTATIC DAMAGE
OR DECREASE IN RELIABILITY.
HANDLING PRECAUTIONS REQUIRED.
TOTAL ACCESS
No power to unit
Power up and initialization OK
Unit is in Out-of-Service – Unassigned mode
Unit has an equipment failure
Normal Operation
Soft failure (e.g. RDI)
LOS, LOL, or other hard alarms on optical
interface
Unit in Test (e.g. Loopback) with an alarm present
on the Optical Interface
DS3 disabled
DS3 normal operation
Soft failure (e.g. RDI)
LOS, LOL, or other hard alarms on DS3 interface
Unit in Test (e.g. Loopback) with an alarm present
on the DS3 Interface
® OPTI-T200
1
The OPTI-T200 is a T200 mechanics card which will fit standard T200 and T400 enclosures.
Ensure the appropriate chassis is installed before proceeding with the installation.
Carefully insert the OPTI-T200 halfway into the selected slot. Route the fiber cables to the
front panel and approximately 4 inches past the SC receptacles (to create slack). Gently but
firmly push the OPTI-T200 all the way into the slot, being careful not to pinch the fibers
between the front panel and the shelf.
WARNING: Once fully inserted into the chassis, the module will be powered (provided power
is connected to the chassis).
2
When the OPTI-T200 powers up, it performs a self-test. The front panel LEDs illuminate for
approximately 8 seconds. The self-test is complete once the STATUS LED illuminates
Green.
NOTE: Simultaneous T/R & T1/R1 contact closures used to indicate internal unit failure, loss
of OC-3/DS-3 inputs, or loss of power.
POWER: –48VR = Pin 17, –48VDC = Pin 35, Frame-GND = Pin27.
JOB
A
ID