Page 1
Can the ROYAL EZ be attached to my chair? 6” 1” ” ¼ 18” - 24” 1. Chair Width 2. No Obstruction 3. Stretcher Bar 4. Leg Dimension The ideal chair width The chair should be free If the chair is equipped with...
Page 2
3/16" Eye ID Wood Eyescrew PLEASE DO AN INVENTORY COUNT BEFORE STARTING. IF YOU ARE MISSING OR NEED TO ORDER REPLACEMENTS PARTS, PLEASE CONTACT COMFORTEK AT 1-888-678-2060. FOR ADDITIONAL ONLINE REFERENCE VISIT WWW.CTSMANUFACTURING.NET/ROYAL-EZ. TOOLS REQUIRED: POWER DRILL 1/4” & 1/16” DRILL BIT...
Page 3
PLEASE VERIFY THAT YOUR CHAIR MEETS ALL THE REQUIREMENTS AS STATED IN THE PACKAGING (’CAN THE ROYAL EZ BE ATTACHED TO MY CHAIR’) BEFORE STARTING. CARE SHOULD ALWAYS BE TAKEN WHEN USING POWER TOOLS AND SHOULD ONLY BE HANDLED BY EXPERIENCED USERS.
Page 4
REAR WHEEL DRILLING INSTRUCTIONS STEP 3 • Remove existing rear leg glides. • REAR LEGS Place the chair onto a flat surface. Measure up 1 1/8” from the (BACK VIEW) floor and place a mark on the inside of each rear leg. This marks the center of the hole to which the rear wheels will be attached.
Page 5
Wood Eyescrew (#21), ensuring that it is fully threaded into the seat of the chair. NOTE: The purpose for the Elastic Cords is to keep the front wheels of the ROYAL • Place one end of the Elastic Cord (#20) through the 3/16“ Wood Eyescrew (#21).