Samsung SGH-E250D W Service Manual page 56

1) Unscrew 4 screws
9
2) Disassemble the upper with a couple of
thumbs pressing the point of picture
1) Be careful of body damage and scretch
1) Remove the tape covering FPCB Connector
11
2) Disassemble FPCB after lifting Connector
1) Be careful of body damage and scretch
2) Be careful of damaging F-PCB
SAMSUNG Proprietary-Contents may change without notice
This Document can not be used without Samsung's authorization
Disassembly and Assembly Instructions
1) Match the hole of LOWER and FRONT
10
holding up the slide
2) Draw out the FPCB from the hole
1) Be careful of cutting wire
2) Be careful of body damage and scretch
1) Disassemble Speaker, Motor
12
2) Remove the tape on the Camera Connector
3) Disassemble the Camera taking down the
top of the camera
1) Be careful of body damage and scretch
2) Be careful of damaging camera F-PCB
11-3