Page 2
PREFACE – QUALITY PHILOSOPHY You have chosen the fireplace insert accessory by SPARTHERM. Thank you very much for your trust in our company. In a world of excess and mass production, our company stands for the values expressed by our owner, Mr. Gerhard Manfred Rokossa: „High technical quality combined with contemporary design, and service to the...
CONTENT 1. Scope of Supply 6. Maintenance 6.1. Battery Replacement 2. General Information 6.2. Setting the Switch-on Temperature 2.1. Blower Unit 6.3. Setting the Radio Frequency 3. Description of Function 7. Cleaning 4. Installation Instructions 8. User Guide 4.1. Blower Unit 4.2.
Installation 1. SCOPE OF SUPPLY example Temperature sensor Varia 1Vh The S-Vent 100 modular forced convection system is supplied in a folding box containing: • Blower unit with air distributor • Control unit with remote control Blower unit • Temperature sensor with approx. 2 metres connecting lead •...
Please note: • In heating mode, with blower stage III: 430 m • The S-Vent 100 modular forced convection system may only be operated in conjunction with a wood-burning fireplace insert. The total of the individual operating states is not reached in heating mode •...
4.2. PIPE CONNECTIONS • We recommend making the power supply via a switchable socket. The advantage of this is that the power to the system can easily be switched off during the summer season and for maintenance. The pipe connections should be fastened to the lower part of the convection air housing using the self-tapping screws supplied, with the injection port 4.1.
4.3. FLEXIBLE ALUMINIUM TUBES designing the covering so that the control unit is positioned near an air grille. That way, the operating status display can be checked at any time The flexible aluminium tube supplied should be divided into the necessary and accessibility is ensured.
All the functions of the S-Vent 100 forced convection system are controlled via the radio remote control supplied with the system. There is no need for 4.7.
5.2.1. MANUAL MODE Press the button to cycle through the blower speeds. Description: In this mode the operator selects the blower speed via the Button Audible Signal Blower remote control. The integral temperature sensor is not active. The desired first press one short Stage 1...
4. Press the PROP button to set a lower value. Press the button to set a higher value. The set temperature value is indicated audibly by a The S-Vent 100 modular forced convection system is maintenance-free by corresponding number of beeps (1 beep for 40°C; 9 beeps for 80°C).
8. USER GUIDE 6.3. SETTING THE RADIO FREQUENCY It may be advisable to alter the transmission frequency via DIP switches in Problem Solution certain circumstances (e.g., if several remote controls all transmitting in the The operating status • Switch on at main switch or insert plug into socket. 434 MHz range are in use).
CONDITIONS absorbers, electronic and electrical components such as exhausters, gover- nors, original spare parts, all purchased parts and safety devices. Spartherm Feuerungstechnik GmbH gives a 6-month warranty on wearing parts around 9.1. SCOPE OF APPLICATION...
Damage and compensation claims not based on a defective unit supplied • Improper transport and/or incorrect storage by Spartherm Feuerungstechnik GmbH are excluded and are not covered by • Improper handling of fragile components such as glass and ceramics the warranty undertaking. This does not apply to statutory warranty claims •...