Advertisement
Installation
Note: SE81ac devices work best when placed right-side-up on a flat surface.
Mounting an SE81ac on a wall or ceiling is not recommended or supported.
1. Connect a LAN port on the SE81ac mesh extender to your PC using an
Ethernet cable.
2. To connect a broadband device:
Connect one end of an Ethernet cable to the WAN port on the
l
SE81ac and connect the other end of the cable to the broadband
device.
Connect one end of another Ethernet cable to the broadband
l
modem and connect the other end of the cable to the wall jack
installed by your provider.
3. Plug the power adapter to the wall outlet and then connect the other
end of it to the Power port of the SE81ac. Your SE81ac automatically
sets up to connect to the Internet. The LED on the top front edge of the
device glows red ( ) and then white ( ) as it sets up for use. When the
SE81ac is ready for use, the LED glows green ( ).
This process may take a few minutes to complete before you can begin using
your Internet applications (browser, email, etc.). If you are unable to connect
to the Internet, confirm that all cable connections are in place and the SE81ac
is plugged in.
Advertisement
