Assembling The Blower; Converting From Blower To Vacuum - Toro 51594 Operator's Manual

Setup

Assembling the Blower

Install the blower tube and then the inlet cover onto the blower housing.
Important: You must install the blower tube before installing the
inlet cover because the inlet cover hooks onto the blower tube.
The blower will not run unless the bottom inlet cover is locked
in place.

Converting from Blower to Vacuum

The impeller rotates for a few seconds after you turn off the
blower and can cut or injure fingers.
Do not remove the bottom inlet cover when the motor is
running or when the unit is plugged into a power outlet.
1. Remove the inlet cover and the blower tube from the blower
housing.
2. Install the vacuum tube onto the blower housing.
Important: The vacuum will not run unless the vacuum tube
is locked in place.
3