Usb Ports - Cisco Catalyst IR1800 Rugged Series Installation Manual

Product Overview
RS232
2 Received Line Signal Detector
3 DTE Ready
4 Signal Ground
5 Received Data
6 Transmitted Data
7 Clear To Send
8 Request To Send

USB Ports

There is a single USB port with a Type-A connector on the front panel. The port is USB 2.0 only, and can be
used for USB sticks. It is not recommended to be used in a hazardous location without mechanical constraint.
All front panel USB ports are equipped with a screw hole for mechanical constraint. The USB port can provide
a maximum current of 500mA at 5V.
There is a single USB port (micro-B) that is provided for console access on the front panel. If your laptop or
PC warns you that you do not have the proper drivers to communicate with the device, you can obtain them
from your computers manufacturer, or go here:
https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx
Latest VCP Drivers do not work with MAC OS 10.14.x and beyond. If you require OS X 10.4 support, please
install version 3.1 of the VCP driver.
Caution
If you are connecting to the USB port:
• a connection (to the USB port) can only be made in a non-hazardous environment
• the USB port cover must be reinstalled before the router can be deployed in a hazardous environment
DCD input output
DTR output input
COM
RxD input output
TxD output input
CTS input output
RTS output input
Cisco Catalyst IR1800 Rugged Series Router Hardware Installation Guide
RS485 Full Duplex RS485 Half Duplex
TX+ output T X / R X -
RX- input
COM COM
RX+ input
USB Ports
<->
23