Husqvarna K 535i Workshop Manual page 18

4. Push the blade shaft with a mandrel and the first
bearing and the blade shaft is removed.
5. Push the second bearing with the mandrel to
remove it.
Note: It is also possible to remove the bearing with an
internal bearing extractor and slide hammer.
18 - Repair instructions
Servicing tools overview on page 7
Refer to:
6.17.2 To assemble the blade shaft bearings
Use the bearing tools to install the bearings and the
Servicing tools overview on page 7 .
blade shaft. Refer to
1. Push the bearing onto the blade shaft. Use the
smaller hole of the bearing press.
2. Put the adapter as a support before you put the
bearing and the blade shaft onto the cutting head.
Note: You must use the adapter. The blade side of
the cutting head is not at a right angle to the blade
shaft.
744 - 002 -