Harman Kardon Citation Amp Manual page 17

5650 - 5850 MHz and that these radars could cause interference and/
or damage to LE-LAN devices.
Les utilisateurs devraient aussi être avisés que
(i) les dispositifs fonctionnant dans la bande 5150 - 5250 MHz sont
réservés uniquement pour une utilisation à l'intérieur afin de réduire
les risques de brouillage préjudiciable aux systèmes de satellites
mobiles utilisant les mêmes canaux;
(ii) le gain maximal d'antenne permis pour les dispositifs utilisant les
bandes 5250 - 5350 MHz et 5470 - 5725 MHz doit se conformer à la
limite de p.i.r.e.;
(iii) le gain maximal d'antenne permis (pour les dispositifs utilisant
la bande 5725 - 5825 MHz) doit se conformer à la limite de p.i.r.e.
spécifiée pour l'exploitation point à point et non point à point, selon le
cas.De plus, les utilisateurs de radars de haute puissance sont désignés
utilisateurs principaux (c.-à-d., qu'ils ont la priorité) pour les bandes
5250 - 5350 MHz et 5650 - 5850 MHz et que ces radars pourrai ent
causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
Warning: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
High power radars are allocated as primary users of the 5.25 to
5.35 GHz and 5.65 to 5.85 GHz bands. These radar stations can cause
interference with and/or damage this device. No configuration
controls are provided for this wireless equipment allowing any change
in the frequency of operations outside the FCC grant of authorization
for US operation according to Part 15.407 of the FCC rules.
FCC/IC Radiation Exposure Statement: This equipment complies with
FCC/IC RSS-102 radiation exposure limits set forth for an uncontrolled