Behringer SUPER FLANGER SF400 User Manual

Thank you for showing your confidence in us by purchasing the BEHRINGER SUPER FLANGER SF400.
This ultimate Flanger delivers the whole range of effects from vintage to modern flanging effects—at the
touch of a footswitch. Experience any sounds from classic analog flangers to super-thick and swirling
flanging effects plus a new Gate/Pan mode.
The MODE knob switches between different flanger-type effects.
Standard:
Ultra:
Gate/Pan:
Momentary:
With the MANUAL control, you can adjust the center frequency to which the effect is applied.
Turn up the DEPTH control to achieve a fuller and deeper effect sound.
The RATE control determines the speed of the flanger effect.
The RES(onance) control determines the amount of output signal fed back to the flanger input
to increase the resonance frequency. Consequently the flanger effect gets more intensive.
The ON/BATT LED illuminates when the effect is activated. It also serves as a battery level
indicator.
Use the footswitch to activate/deactivate the effect. If you depress the pedal for more than
two seconds, you are able to enter a tempo by tapping the pedal several times in time with the
music (not in MOMENTARY mode). Depressing the pedal once again for more than two seconds
quits the tempo input mode.
The 1/4" TS connector (GTR IN) is optimized for guitars. Use connector BASS IN
optimized bass guitar performance.
The 1/4" TS connector (OUT A) sends out a mono signal to your amp/combo. For stereo
applications, use connector OUT B additionally.
The 1/4" TS connector (BASS IN) is optimized for bass guitars. Use connector GTR IN
optimized guitar performance.
The 1/4" TS connector (OUT B) sends out a signal, which together with OUT A, forms a stereo
signal that can be used e.g. to feed a mixer.
Use the DC IN connection at the front of the unit to plug in a 9 V power supply (not included).
The BATTERY COMPARTMENT is located underneath the pedal cover. To install or replace the 9 V
battery (not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful
not to scratch the unit.
The SF400 has no On/Off switch. It is operable as soon as you insert a plug into one of
the IN connectors. Disconnect the plug, if you don't use the SF400. In doing so, you can
extend the life time of the battery.
SUPER FLANGER SF400
1. CONTROLS
Top view
Classic flanger.
Strong flanger with more depth.
Mono slicer effect or swirling stereo flanger, depending on mono
or stereo output use.
Momentary flanger e.g. for single notes. Hold the pedal depressed
for effect activation.
for
for