Installation Kit Parts List; Tools Required; Equipment Required - HP ESG E4400B Installation Note

HP ESG E4400B, E4420B, E4421B, E4422B and HP ESG-D
E4430B, E4431B, E4432B, E4433B Series Signal Generators
Firmware Upgrade Kit: Part Number E4400-60174
Product Affected: . . . . . . . . . . . . . . . . . . . . . . . .
Serial Numbers: . . . . . . . . . . . . . . . . . . . . . . . .
Options: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
To Be Performed By: . . . . . . . . . . . . . . . . . . . . . .
Estimated Installation Time: . . . . . . . . . . . . . .
Estimated Verification Time: . . . . . . . . . . . . . .
Introduction
The firmware revision is changed by downloading the updated firmware files via computer RS-232
interface or the HP Access Website. This installation note includes separate procedures for PC, laptop,
or palmtop computers.

Installation Kit Parts List

Table 1 Parts Kit E4400-60174 Contents
Item Quantity
1 1
2 1
3 1

Tools Required

5-mm nut driver, HP part number 8710-1219

Equipment Required

The computer controller may be a PC (IBM compatible), laptop (HP OmniBook), or palmtop
(HP 200LX). Notice that the palmtop must have 256 kB available memory for DOS. The required
equipment is listed under each procedure.
A kit containing the RS-232 parts listed in each procedure can be obtained by ordering the
NOTE
RS-232 Cable Kit, HP part number E4400-60049.
Installation Note E4400-90235
Description
Firmware DOS disk upgrade
RS-232 Cable Kit
Installation Note
HP ESG E4400B, E4420B, E4421B, E4422B
HP ESG-D E4430B, E4431B, E4432B, E4433B
Series Signal Generators
All
All
(X) HP Service Center
(X) Personnel Qualified by HP
(X) Customer
1 hour
1 minute
Part Number
E4400-10007
E4400-60049
E4400-90235
3