Detergent; Setting The Water Softener Level - Baumatic BDW15 Instruction Manual

SETTING THE WATER SOFTENER LEVEL

YOU CAN ADJUST THE AMOUNT OF SALT USED BY THE DISHWASHER TO SOFTEN WATER TO GET
THE BEST WASHING RESULTS, BASED ON THE HARDNESS OF WATER IN YOUR AREA.
1 UNSCREW THE CAP FROM THE SALT
CONTAINER.
ADJUSTMENTS SHOULD BE MADE ACCORDING TO THE TABLE BELOW:
WA TER H ARDNESS
Clarke Degrees
0~ 14
14 ~3 6
36~ 71
71
Conta ct your l oca l wa ter boa rd for infor ma ti on on the ha rdne ss of your w ate r suppl y.

DETERGENT

To OPEN the DETERGENT DISPENSER DOOR, use the CATCH on its LOWER SIDE.
*NOTE: SEE P.13 – WASH CYCLE TABLE for AMOUNT of DETERGENT to use.
NOTE:
• ALWAYS CHECK THE WASH CYCLE TABLE
FOR DOSAGE ADVICE. NEVER OVERFILL
THE DISPENSER.
• DO NOT OVERDOSE TO PREVENT THE
FORMATION OF DEPOSITS (THE WATER
SOFTENING FEATURE ALREADY TAKES CARE
OF THIS!).
THE HARDER YOUR WATER, THE MORE DETERGENT
YOU MAY NEED. ADJUST THE DOSE JUST BY SMALL
AMOUNTS UNTIL YOU FIND THE CORRECT AMOUNT
OF DETERGENT TO USE.
BAUMATIC BDW15 dishwasher user manual
dH mmol /l
0~ 18 0~ 1. 8
18 ~4 4 1. 8~ 4.4
44 ~89 4. 4~ 8.9
89 8. 9
2 THERE IS A RING ON THE NECK OF THE
CONTAINER. ROTATE THE RING IN AN
ANTICLOCKWISE DIRECTION FROM THE "-"
SETTING TOWARDS THE "+" SETTING
ACCORDING TO THE HARDNESS OF WATER
IN USE. SEE TABLE BELOW.
1. THE SALT CONTAINER MUST BE REFILLED WHEN THE
SALT WARNING LIGHT COMES ON. ALTHOUGH THE
SALT CONTAINER MAY BE FULL, THE INDICATOR LIGHT
MAY NOT GO OUT UNTIL THE SALT HAS DISSOLVED.
2. IF THERE ARE SALT SPILLS, A SOAK PROGRAM CAN
BE RUN TO WASH AWAY SPILLAGE BEFORE USING THE
MACHINE.
3. CLEAR ANY SALT GRANULES AWAY FROM THE
CONTAINER OPENING.
Salt consum ption
Select o r Po siti on
/
-
M E D
+
"
How much do I use?"
6
NOTE
Au to nomy
(c ycl e s/ 1 .2kg s)
(g ra m/cycle)
0
20 60
40 30
60 20
6
/