System - Power Supply Connection - Bosch rexroth NYCe 4000 Instructions Manual

14/45
Interfacing
Designation
on base plate
An0
An1
An2
An3
An4
Fdig0
Fdig1
Fdig2
Fdig3
Fdig4
Dig0
Dig1
Dig2
Dig3
Dig4
note 1 The text "DP NY4130 0" is only on the NYS04.2-ST-01-ULNN-NY4013.
note 2 The text "DP NY4130 2/3" is only on the NYS04.2-ST-04-ULNN-NY4043.
Tab. 9-1: System housing connections
9.2 24V System – Power supply connection
The connector "24V SYSTEM" connects the 24V power supply to the system
housing for all modules in the module holder.
NOTICE
Observe the correct polarity of the power supply connections.
Connect the minus at the power supply side of the cable to the housing and/or
to protective earth (if this is not already the case). If the cable has a shield,
connect the shield at the system housing side to the shield pin in the connector
or the connector housing, and connect the shield on the other side of the cable
to the housing of the power supply.
Bosch Rexroth AG R911337318_Edition 09
Connection type
Analog I/O connector
1 connector for each slot
Fast digital I/O connector
1 connector for each slot
Digital I/O connector
1 connector for each slot
Protective earth
connection
The system housing has no provisions against
wrong polarity connection of the 24V System
power supply.
NYCe 4000 Multi-axis motion control
Connection Connection
(base plate) (cable)
9-pin sub-D
9-pin sub-D female
male with
4-40 UNC
with 4-40 UNC screws
nuts
9-pin sub-D
9-pin sub-D male
female with
4-40 UNC
with 4-40 UNC screws
nuts
25-pin sub-D
25-pin sub-D female
male with
4-40 UNC
with 4-40 UNC screws
nuts
M5 threaded
screw
system