Place The Receiver Unit Stand-Alone Near The Tv - Sony BRAVIA DMX-WL1 Reference Manual

3
Slide the receiver unit onto the bracket.
If the Wireless LINK LEVEL is low, the receiver
unit can also be attached on the top right side of
the rear TV panel which may provide better
reception. In this case, attach the receiver unit by
rotating 180 degrees.
Remove the receiver unit from the TV Mounting
bracket on the rear TV panel, remove the TV
Mounting bracket/Plastic Fasteners using a
Phillips Screwdriver, remove the screws holding
the adapter and rotate 180 degrees, then secure the
screws again, attach the TV Mounting bracket and
the receiver unit.
Remove the screws
Rotate 180 degrees
18
~
• If no Guide Pins or screw holes are found on the rear
TV panel, it is not designed to mount the receiver unit
to the TV.
In case of small TV, the Wall-Mount bracket of the TV
might interfere with the receiver unit.
If this is the case, place the receiver unit horizontally
on a table or stand.
Place the Receiver Unit Stand-alone
Near the TV
If the Wireless LINK LEVEL is still low, place the
receiver unit horizontally near the TV.
Find a location where all LINK LEVEL LEDs are
lit.
Plastic
Fastener
Guide Pin
~
• Be sure to remove the receiver unit from the back of
the TV before moving the TV.
Secure the screws