Assembly - Husky HYLS-7208 Use And Care Manual

Assembly

1
Attaching the side handle
NOTE: The side handle could be installed on either
the left or right side of the workbench as desired.
□
Position the side handle (B) over pre-installed nuts on
the desired side of the workbench (A).
□
Insert the handle bolts (AA) through the holes on the
side handle (B).
□
Use a wrench (EE) or 10 mm wrench/socket (not
included) to tighten the handle bolts (AA) to the
workbench (A).
□
Install the plugs (CC) over the pre-installed nuts on the
opposite side of the side handle (B).
BB
B
AA
A
A
2
Attaching the casters
WARNING: At least two people are needed to lay
down the workbench. Do not attempt this alone.
□
Lay the workbench (A) on its backside.
□
Position the swivel casters (D) on the side of the
workbench (A) of your choice and align the holes to the
pre-installed nuts on the underside of the workbench
(A).
□
Use the wrench (EE) to fully tighten the caster bolts (BB)
to the workbench (A).
□
Repeat these steps to install the fixed casters (C).
NOTE: Make sure to install both of the swivel
casters (D) on the same side.
NOTE: For ease of use, place swivel casters (D) on
the side you will regularly push or pull.
NOTE: If you plan to push the workbench against a
wall, place swivel casters (D) on the front long side
for ease of access.
EE
C
BB
6
D
EE