Korg iS35-HD Additional Information page 11

3 Move the cursor to CPY (COPY) and press ENTER/YES.
4 Hold the DISK/GLOBAL or TRK SELECT button pressed and use the TEMPO/
VALUE buttons (or the DIAL) to select the disk unit (partition or disk drive) that con-
tains the files to be copied. The name of the origin disk unit is shown on top left.
5 Move the cursor to the name of the disk unit to which the files must be copied in the
second line of the display and select the destination unit with the TEMPO/VALUE
buttons (or the DIAL). Now you can copy the files in any of the three procedures indi-
cated below:
A - Copying a single file
This function allows you to copy a single file from the origin to the destination unit.
1 Move the cursor to the name of the file to be copied.
2 Select the file with the TEMPO/VALUE buttons (or the dial).
3 Press ENTER/YES to start copying.
Note: The "FILENAME.MID exists" message will appear (where FILENAME is the
name of the file being copied) if the destination unit contains a file under the same
name. Press ENTER/YES to confirm copying or EXIT/NO to cancel. The first free
progressive number will be assigned to the file.
B - Copying all the midifiles (songs, .MID files)
This function allows you to copy all the midifiles contained in the disk or hard disk
partition.
1 Move the cursor to the name of the files to be copied.
2 Hold the [UP/+] button pressed to go to the end of the song list. The last item but one
on the list is the "MIDI Files" option. Select this option.
3 Press ENTER/YES to start copying.
Note: When copying all the midifiles, the files in the origin disk unit will be merged
with the files in the destination disk unit. If the origin disk unit contains files that
10
Origin unit
File to be copied Destination unit
Chapter 3