Disassembly - Kenwood NX-3720HG Service Manual

3.1 Disassembly Procedure
(1) Remove the cabinet, top packing and shielding plate of the
transceiver.
Cabinet
(2) To remove the panel assembly, first turn the transceiver
upside down.
Then, insert a flat-head screwdriver into the holes of the
chassis and tilt it in the direction as shown by the arrow.
Holes
Panel assembly
1-30 (No.RA054<Rev.001>)
SECTION 3

DISASSEMBLY

(3) Disconnect the flat cable from connector of the panel
assembly.
(4) Remove the speaker lead from the holder hook.<1>
Remove the speaker connector from the display unit
connector.<2>
Insert a flat-head screwdriver at the stamp position (arrow
mark) in the speaker holder.<3>
Speaker holder Speaker holder
Tilt the screwdriver in the figure direction <4>, then remove
the speaker holder from the front panel.
Flat cable
<2>Speaker connector <2>Speaker connector
<3> <3> <3>
<1>Holder hook <1>Holder hook
<4> <4>