2.
Remove input shaft bearing retainer bolts and lock
washers (fig.
M).
6
3.
Tap end of input shaft to drive bearing out front of
differential cover and lift out the input shaft assembly
and shims (fig.
M).
6
4.
If lockout shift components have not been removed, slip
the sliding clutch out of shift fork and remove clutch
from cover.
Fig. 3M ~Rem oving Input S haft Flange Nut
Fig. 2M~Tandem Rear Axles and Power Divider
Vacuum Operated Differential Lockout
1.
2.
REAR AXLE DIFFERENTIAL CARRIER 4-33
Remove shift lever boot from shift lever (fig. 7M).
Remove lever pivot pin cotter pin and pull pivot pin and
lever out of bracket.
©
Fig. 4M--Removing D ifferential Carrier Cover Bolts
CHEVROLET OVERHAUL M A N U A L SUPPLEMENT