Axis P3304 User Manual page 11

Half-duplex mode
The Talk/Listen button is used to switch between sending and receiving audio. The button can be config-
ured from the Audio tab in the AMC Control panel:
• Push-To-Talk mode: Click and hold the button to talk/send, release the button to listen.
• Toggle mode: Click once to switch between talking and listening.
Simplex – Network Camera speaker only mode
To send audio, the Talk and Microphone buttons must both be enabled. Click either button to stop audio
transmission.
Pan/Tilt/Zoom controls
The following controls are available if digital PTZ is enabled, see PTZ, on page 22. The administrator can enable and disable the
controls for specific users under System Options > Security > Users > User List.
Click the Emulate joystick mode button and click in the image to move the camera view in the direction of the
mouse pointer.
Click the Center mode button and click on a position in the image to center the camera view on that position.
Pan, Tilt and Zoom bars — Clicking a position directly on the bar moves the camera view directly to the new posi-
tion in one smooth movement. Clicking on the arrows at the ends of a bar causes an incremental change. Clicking
Zoom out to overview image will set the camera to the minimum zoom position. In this position, the camera
cannot pan or tilt.
Click the Ctrl panel button to open the PTZ control panel which provides additional PTZ controls.
User-defined buttons can also appear in the Control panel, see Advanced, on page 23.
Click the Home button to steer the camera to the Home position. The Home position is defined under
Setup > PTZ> Preset Positions.
11
AXIS P3301/AXIS P3304