Network - Upnp; Network - Rtp / Mpeg-4; Network - Bonjour; Ports & Devices - Axis 210A User Manual

AXIS 210A/211A - System Options
48

Network - UPnP™

The cameras includes support for UPnP
your computer, the camera will automatically be detected and a new icon will be added to
"My Network Places."
Note:
UPnP must also be enabled on your Windows XP or ME computer. To do this, open the Control Panel from
the Start Menu and select Add/Remove Programs. Select Add/Remove Windows Components and open
the Networking Services section. Click Details and then select UPnP as the service to add.

Network - RTP / MPEG-4

These settings are for the IP addresses, port numbers, and Time-To-Live values to use for
media streams in the MPEG-4 format. Only certain IP addresses and port numbers should
be used for these streams. For more information, please see the online help.

Network - Bonjour

Your Axis network camera includes support for Bonjour. When enabled, the camera is
automatically detected by operating systems and clients that support this protocol.
Ports & Devices
I/O Ports - the pinout, interface support and the control and monitoring functions
provided by this connector are described in The I/O Terminal Connector, on page 51.

LED Settings

The Status indicator LED on the front of the camera can be set to flash at a configurable
interval (or to not light up at all) whenever the unit is accessed. For a listing of all LED
behavior, see page 8, or the online help.
Note:
The LED does not flash when the stream is retrieved using MPEG-4 multicast.

Maintenance

• Restart - The camera is restarted without changing any of the settings. Use this method
if the unit is not behaving as expected.
• Restore - The unit is restarted and most current settings are reset to factory default val-
ues. The settings that will not be reset are as follows:
• the boot protocol (DHCP or static)
• the static IP address
• the default router
• the subnet mask
• the system time
• Default - The default button should be used with caution. Pressing this will return all of
the camera's settings (including the IP address) to the factory default values.
, which is enabled by default. If also enabled on
™