Setup Software; Installation; Files; Configuration - Qualitrol 111-300 Series Instruction Manual

S S S S S S S S
ETUP ETUP ETUP ETUP OFTWARE OFTWARE OFTWARE OFTWARE
NOTE: The software is NOT supplied with every unit – It can be used to
The ETM Configuration software is a Windows based program that allows the
user to setup parameters in Qualitrol Model 111 and Model 118 series electronic
temperature monitors via the RS232 port of the ETM. There is some variation in
what parameters can be set in each model. The software only shows parameters
available to the model being configured.
The software allows configuration values to be entered into a setup screen and
then sent to the ETM and/or saved to a configuration file for future use.
Operation of the software consists of these menu selections.

Installation

Installation Installation Installation
Run SETUP.BAT on the installation CD. This will create a directory
C:\QualiTROL on the hard drive, and will install the program and default
configuration files in that directory. It will also put an icon on the desktop to
start the program.

Files

Files
Files Files
When the program first starts, you must either select an existing configuration
file or start a new configuration file. Until a file is assigned or selected the other
menu items are not available.
configuration. The program will ask what Model you are going to configure and
then will use the standard Windows screen to allow you to assign a file name to
the configuration file.
select an existing configuration file. The configuration file contains the type
ETM being configured. If the default file is chosen, the values can be changed
and stored as the new default values, or they can be stored as a different
configuration name.
Select Comm Port – Selects the computer Comm Port to use to talk to the ETM
Exit- Exits the program

Configuration

Configuration Configuration Configuration
configuration information. One can then download the configuration to an ETM
and / or save it to a configuration file. It is also possible to upload the existing
configuration from the ETM to the Configuration screen
The configuration Software allows the user to set up the following parameters of
the ETM:
configure multiple varieties of units. It is ordered as a separate line
item (KIT-032-1). This includes a CD with all of the software, and
a communications cable to connect it to all of the various models.
NEW – Use the NEW button or use File / New Config File to start a new
OPEN – Use the OPEN button or use File / Open Existing Config File to
View / Change Config – Opens a screen that allows the entry of
1 4
E l e c t r o n i c T e m p e r a t u r e M o n i t o r